Opinion: electric self charging is the future for vehicle mounted aerial platforms

Premium Content

09 February 2026

Marc Paish, Managing Director of UK vehicle mounted aerial lift specialist Aldercote discusses why he thinks self-charging electric systems are the future for vehicle mounted access.

Across the utilities, local authority and network services sectors, there is growing pressure to rethink how vehicle-mounted access equipment is powered, writes Paish. 

Decarbonisation targets are a major driver, but they sit alongside equally pressing demands: lower fuel costs, reduced noise in urban environments, better working conditions, improved productivity and longer vehicle life.

Marc Paish - Aldercote Marc Paish, Managing Director, Aldercote. (Image: Aldercote).

These pressures are exposing a long-standing inefficiency in the access industry: the reliance on power take-off (PTO) systems driven by an idling diesel engine.

The inefficiency we have lived with for too long

A conventional PTO system requires the vehicle engine to run continuously while the platform is in use. From an engineering perspective, this is painfully inefficient. A diesel engine ticking over consumes around 10kW, yet the power required to operate a typical van mounted platform is a fraction of that.

Measured across a realistic duty cycle, the average power demand is a few hundred watts, so about 95% of the energy burned by the engine is simply wasted. Soot also accumulates when engines run on tick-over so servicing costs increase.

For fleet operators looking to decarbonise operations that still rely on diesel vehicles, this inefficiency is increasingly hard to justify.

Why electric systems are gaining traction – and where they fall short

Electric access systems are not new, and they are clearly an improvement on PTO. Electric motors only draw power when needed so are inherently more efficient than idling engines.

However, many early systems were simple adaptations of engine-driven hydraulics. The engine was replaced by an electric motor, but the hydraulic system stayed the same. While better than PTO, significant inefficiencies remained, and by ignoring the flexibility that electric drive could offer, this was an unimaginative solution.

A system-level rethink

At Aldercote, we began by asking, ‘how much energy is actually required for each lift?’

Roughly speaking, our customers typically lift about 500kg to about 10m. GCSE maths tells you this requires 50kj. Compare that with the 2000kj energy in a fully charged car battery, and it’s clear that electric platforms should not need batteries weighing hundreds of kilograms.

From there, we simply worked out the best and most efficient way to pump oil using an electric motor – and the good news is that the hydraulic system is not just more efficient, it is simpler and more reliable too.

The result is that E-drive delivers a step-change in efficiency and carbon emissions, with lower fuel consumption and reduced service and maintenance costs.

In practice, if energy is not wasted, platforms only need relatively small battery packs. Around 20 full operating cycles can be achieved from a pair of small lead-acid batteries, with recharging taking place during normal vehicle transit.

Electric drive also allows precise control over energy delivery, resulting in faster lift speeds, smoother motion and millimetre-level accuracy. Noise levels drop to around 55dB, which is increasingly important in residential and urban working environments – and, of course, operators no longer need to work in a cloud of diesel fumes.

What customers are really asking for

In practice, sustainability requirements from utilities, councils and network operators are not just about cutting carbon emissions. Customers are looking for solutions that also deliver lower fuel and servicing costs, improved productivity, reduced noise and reliable equipment that’s simple to maintain and future-proof.

Self-charging electric systems address these needs as a direct result of improved engineering efficiency – not added complexity.

The wider challenge for the access industry

Power systems are only one part of the picture. Customers are also facing challenges around payload limits, vehicle availability, skills shortages and tighter urban working constraints.

The lesson from electric drive development is that the access industry must be prepared to challenge long-established solutions and redesign from first principles. Those that invest in engineering-led innovation will be better placed to support customers balancing decarbonisation with the practical realities of day-to-day operations.

Latest News
Genie to go ‘beyond the machine’ at ARA Show
Manufacturer will shpw developments in digital solutions, parts, accessories and service 
Rentease appoints CEO
Formally with Genie/Terex, Riwal, Mateco and TVH, Samuel Gozlan brings years of experince to the role 
UK watchdog proposes even higher duty on Chinese excavators
UK trade watchdog the Trade Remedies Authority (TRA) has proposed upping anti-dumping duties on imported Chinese excavators to as much as 80.16%
CONNECT WITH THE TEAM
Murray Pollok Editor, International Rental News Tel: +44 (0)1505 850043 E-mail: [email protected]
Ollie Hodges Vice President, Sales Tel: +44 (0)1892 786253 E-mail: [email protected]
CONNECT WITH SOCIAL MEDIA